Some stupid Single8 questions

[tlatosmd]

Hey Jörg, have you checked Frank Bruinsma's S8 Reversal Lab on that yet?

[Jam]

Hello Paul Cotto

This is Jam, staff of Tak, he mentioned you before!

Tak like to say hello you.

***************************

Hi jpolzfuss:

Retro X is now produce in Tokyo, but processing still by Andec

Therefore you could order retroX from us, then process and pick up from Andec, you don't need to pay anything to andec, they will charge us directly.

When you order Retro X from us, please mention that you are located in berlin, we will inform Andec that you are german customer.

Best
Jam

[jpolzfuss]

Hey Jörg, have you checked Frank Bruinsma's S8 Reversal Lab on that yet?

Yes... I still have to check the euro<->yen rates to see whether the Netherlands or Japan will be cheaper ;)

[jpolzfuss]

Therefore you could order retroX from us, then process and pick up from Andec, you don't need to pay anything to andec, they will charge us directly.

When you order Retro X from us, please mention that you are located in berlin, we will inform Andec that you are german customer.

Cool! Thanks for that info!

Jörg

[jpolzfuss]

Films measured:

Fomapan
Fomapan: 0.145mm (processed)*
Fomapan: 0.145mm (not processed)*

That's what Foma says about their FOMAPAN R (100ASA, available as 2x Super 8 mm film (DS 8) among others):

FOMAPAN R is usually produced on a cellulose triacetate safety film base 0.125 mm thick or on a polyester film base of the same thickness when higher demands concerning mechanical resistance and dimensional stability are made on the film.

[kentbulza]

Those were ACTUAL measurements of real Foma DS8, before and after development. Not what might be printed in a spec.